MA200TS Measurement Card

This is the quick live-reading card for the highest-value MA200TS process, feed, and feedback splits.

Use This Card When

actual 208 / 230 V input with a healthy branch, about 50 A protection on 220 V, or about 5000 W non-inverter generator support
correct process and polarity
one plain-steel MIG baseline before aluminum-only or TIG-only complaints
known-good gun path with the tip removed if feed is in question
correct drive-roll pressure for the wire in use
no pedal-based TIG control path is being assumed on this machine

Checkpoint	Where to measure or observe	Healthy expectation	If abnormal, keep diagnosis in...
Source and package baseline	input source, fitted adapter, and machine setup	healthy `208 / 230 V` input with the expected branch support and correct package for the tested process	source, adapter, or package branch before internal repair
Drive-roll pressure baseline	drive assembly	about `4 to 5` for steel and about `2 to 3` for aluminum or flux-cored wire	mechanical feed setup before electrical diagnosis
Wire behavior at power-up	feeder behavior with no trigger command	no wire movement until a real trigger command is given	trigger, support-power, or control-seat branch
Left and right meter response during welding	display during an actual weld	display responds to the active process and does not stay pinned at maximum	feedback cable, hall-sense, or control branch
Process button after display-board work	front-panel button action	moves freely and releases fully	stuck-button or mode-lock branch

Use these only after the measurements prove the complaint follows the aluminum package, external torch path, or current-path hardware.
MA200TS accessories entry: official accessories path
Aluminum kit XOM99035: official product page
Product and package baseline: official MA200TS product page

Stop and correct the source or adapter branch first if the machine is not on healthy 208 / 230 V input or a suitable generator.
Stop and correct feed pressure first if the complaint is only poor or erratic wire movement.
Stop and keep the complaint in the package branch if plain-steel MIG is healthy and only aluminum or TIG mode fails.
Stop if the operator is assuming pedal-based TIG control. That is not the right baseline for this machine.
Stop and fix the button or display seating branch first if the process button does not release cleanly.
Stop using the card and open the full guide if one process is healthy but the failing process still does not align to a clear accessory or feedback branch.