MultiSonic220 Measurement Card

This is the quick live-reading card for the highest-value MultiSonic220 control-state and MIG-only branch splits.

Use This Card When

stick and TIG work but MIG does not
the display flashes like a Christmas tree
the feeder runs at power-up or behaves incorrectly at idle

Prove First

correct process selection
correct polarity connector for the active process
known-good gun path with the tip removed if feed is in question

Fast Measurement Card

Checkpoint	Where to measure or observe	Healthy expectation	If abnormal, keep diagnosis in...
Startup state after reset	panel behavior after documented reset	machine exits debug behavior and boots normally	stored-state, ribbon, or support-power branch
Polarity connector	machine front current path for MIG	tight and correctly installed when MIG is selected	polarity and MIG-only current-path branch
Panel behavior at power-up	live observation	stable display and indicators, not full flash or Christmas-tree behavior	ribbon, control, or power-supply branch
Feeder motor at idle	motor behavior with no trigger command	feeder remains stopped until commanded	power board or support-power branch if motor runs full speed

Official Parts Shortcuts

Use these only after the complaint is proven to follow the external MIG torch, spool-gun, TIG torch, or pedal branch.
MultiSonic220 parts category: official parts path
Aluminum kit XOM99035: official product page
Spool gun 07NS1010: official product page
PRO17 TIG torch WAT31100: official product page
FC25-HD pedal 07002510: official product page

Stop Rules

Stop and correct polarity first if stick and TIG are healthy but MIG has no output.
Stop and reset state first if the display fault clears after the documented recovery sequence.
Stop using the card and open the full guide if feed and display behavior conflict with each other instead of aligning to one branch.

Open Next