CUT40 Fault Workflow Router

This router gives the fastest document order for the highest-value CUT40 complaints.

Complaint Routing

Incoming complaint	Open first	Then open	Then open if the complaint remains	Why this order works
start is unreliable and air routing still looks wrong	CUT40 measurement card	CUT40 parts substitution card	CUT40 board opening map	the fastest path is air and torch proving first, then opening only if the complaint stays internal
guide or stand-off hardware may be the whole complaint	CUT40 parts substitution card	CUT40 guide	CUT40 job packet	tracking complaints stay external and mechanical first, with freehand proof ahead of hardware blame
transfer fails on dirty work or with weak clamp	CUT40 parts substitution card	CUT40 guide	CUT40 job packet	transfer-only complaints still belong to return path and work condition proof
air and torch look healthy but there is still no useful output	CUT40 measurement card	CUT40 board opening map	CUT40 guide	once externals are proven, the route shifts to valve and output branches

Official Parts Exit Paths

If the complaint proves external at any point in the router, use the official parts flow instead of continuing into board work.
CUT40 parts category: official parts path
CB50 torch 07001710: use the official parts path above.
Guide carriage 07CV0037: official product page
Extended tip 07PD0063-10: official product page

Stop Rules

Stop if air-routing correction changes the complaint immediately.
Stop if guide hardware is the only failed branch.
Stop if freehand cutting is healthy and only guide hardware changes the complaint.
Stop and move to the full guide if air, start, and output evidence still overlap after the first pass.

Open Next