PulseWave200 Fault Workflow Router

This router gives the fastest document order for the highest-value PulseWave200 complaints.

Complaint Routing

Incoming complaint	Open first	Then open	Then open if the complaint remains	Why this order works
all 8s on the display or panel-state corruption after arc strike	PulseWave200 measurement card	PulseWave200 board opening map	PulseWave200 guide	the restore-default path is the fastest proof, then the opening map keeps the internal work inside the display-state branch
TIG will not start	PulseWave200 measurement card	PulseWave200 parts substitution card	PulseWave200 board opening map	polarity, simple DC TIG, and gas must be bounded first, then torch or remote, and only then the internal control branch
DC TIG works but AC TIG does not	PulseWave200 measurement card	PulseWave200 board opening map	PulseWave200 guide	this is the cleanest route into the AC-only branch without getting lost in the base TIG setup
complaint follows only one pedal or remote	PulseWave200 parts substitution card	PulseWave200 guide	PulseWave200 board opening map	remote-only complaints should stay out of internal repair until the control device is bounded

Official Parts Exit Paths

If the complaint proves external at any point in the router, use the official parts flow instead of continuing into board work.
PulseWave200 parts category: official parts path
PRO17 TIG torch WAT31100: official product page
FC25-HD pedal 07002510: official product page
FC25-WL wireless pedal 07002515: official product page

Stop Rules

Stop if the complaint disappears with the base torch and no optional control device attached.
Stop if restore-default behavior clears the panel fault.
Stop if simple DC TIG with local control is healthy and only one control branch or AC branch still fails.
Stop and move to the full guide if AC, HF, and panel behavior still remain mixed after the first pass.

Open Next