KickingHorse Measurement Card Pack

This pack collects the highest-value KickingHorse printable measurement cards into one quick bench set.

How to Use This Pack

Start with the card that matches the incoming model.
Use the card for the first live-reading split.
Move to the full guide or bench test sheet as soon as the card isolates the branch.

A100: do not trust the reading split until the machine is on a real 20 A or healthy 3 kW baseline with dry 3/32 in 7018 or 6010/6011.
A220: do not trust the top-end split until the machine is on a true 230 V, ideally 50 A, or healthy 5 kW baseline with dry 7018 or 6010/6011.
For both arc models, treat wrong polarity, hot current-path hardware, or improvised TIG routing as external setup faults first, not as internal electrical failure.

F130: do not trust the trigger-state split until the machine is on factory 0.035 in baseline or a proper 0.030 in conversion, a real 120 V / 20 A source or healthy 3 kW generator, and a cord path that stays within the official 25 ft and full 20 A baseline.
M185: do not trust display or feed splits until the machine is on a real 208/230 V source, the breaker path matches the intended proof level, inductance has been returned to a sane baseline, and preset-versus-actual display behavior has been observed once on a real weld.
For both MIG models, treat wrong wire-size setup, wrong front-end hardware, shared no-feed plus bad-display evidence, or weak source collapse as external or setup proof failures first, not internal electrical evidence.

Model	Card	Best used for
A100	measurement card	branch-power, polarity, OCV, and blinking-light or fan-collapse proving
A220	measurement card	utility-path, polarity, OCV, and current-path heating proving
F130	measurement card	trigger-state proving, front-end isolation, cord-path proof, and source-quality splits
MA200TS	measurement card	feed-on-power-up, maxed display, and process-feedback branch proving
M185	measurement card	display-feedback proving, preset-versus-actual transition, and no-feed overlap separation
P40	measurement card	no-HF, HF-with-no-OCV, and 24 V support-supply splits

If the measurements prove the fault is still external, stop before deeper teardown and use the matching official parts path.
A100: accessories path, ground clamp 07000461, holder 07000460, but only after correct polarity and a supported stick baseline are proven
A220: accessories path, ground clamp 07000461, holder 07000460, but only after correct polarity and a supported stick baseline are proven
F130: accessories path, contact tip KOM32135, product page, but only after factory 0.035 in or a proper 0.030 in conversion and a compliant cord path are proven
MA200TS: accessories path, aluminum kit XOM99035, product page
M185: product page, torch KAM31003, contact tip KOM32135, but only after preset-versus-actual display proof, source proof, and inductance reset still leave the complaint external
P40: accessories path, electrode 07Y2517003, owner manual